| |
Includes battery, antenna, and charger.
| General |
|
Frequency coverage
(Rx and Tx)* |
IC-F3001 136-174 MHz
IC-F4001 400-470 MHz, 450-512 MHz |
| Number of channels |
Total 16
|
| Type of emissions |
16K0F3E/11K0F3E |
| Channel spacing |
IC-F3001 12.5 KHz/25 kHz, 15/30kHz
IC-F4001 12.5/25kHZ |
| PLL channel step |
IC-F3001 2.5 kHz, 3.125 kHz (VHF)
IC-F4001 5KHz, 6.25KHz (UHF) |
| Power supply requirement |
7.2V DC nominal |
| Current drain |
Receive
Transmit |
IC-F3001
70 mA (standby)
250 mA (rated audio)
1.25 A (high) |
IC-F4001
70mA (standby)
330mA (internal SP)
1.3A (high) | |
| Antenna impedance |
50Ω |
| Operating temperature range |
-30°C to 60°C; –22°F to +140°F (radio only |
Dimensions (W×H×D)
(Projections not included) |
58×111×31.0 mm; 29⁄32 × 43⁄8 × 17⁄32 in. (with BP-264) |
| Weight |
330g; 11.6oz (with BP-264) |
| Transmitter |
| Spurious emissions |
70dB typ. |
| Max. frequency deviation |
±5.0kHz/±2.5kHz (wide/narrow) |
| Frequency stability |
±2.5ppm |
| FM hum and noise |
46/40dB typ. (wide/narrow) |
| Output power |
5 W, 2W or 1W Hi, L2, L1)
4 W, 2W or 1W (Hi, L2, L1) |
Audio harmonic distortion
(AF 1kHz 40% deviation) |
1.0/1.5% typ. (wide/narrow) |
| Ext. microphone connector |
3-conductor 2.5 (d) mm (1⁄10")⁄2.2kΩ |
| Receiver |
| Sensitivity |
0.25 µV (typ.) at 12 dB SINAD |
| Adjacent channel selectivity |
73/65dB typ. (wide/narrow) |
| Spurious response rejection |
70 dB (typ.) |
| Intermodulation rejection |
74dB typ. |
| Hum and noise |
52/47dB typ. (wide/narrow) |
| Ext. speaker connector |
2-conductor 3.5 (d) mm (1⁄8") |
Audio output power (at 5% distortion)
Internal SP (w/12Ω load)
External SP (w/8Ω load) |
800mW typ.
400mW typ. | |
|
| Number of channels |
Total 16 (rotary type)
Total 4 (toggle type) |
| Channel spacing |
12.5 KHz, 25 kHz |
| PLL channel step |
2.5 kHz, 3.125 kHz (VHF)
5KHz, 6.25KHz (UHF) |
| Output power |
5 W, 2W or 1W (VHF)
4 W, 2W or 1W (UHF) |
| Spurious emissions |
73dBc typ. |
| Adjacent channel power |
at 25KHz
at 12.5KHz |
70 dB typ.
60 dB typ. | |
| Frequency stability |
|
| Sensitivity |
0.25 µV (typ.) at 12 dB SINAD |
| Adjacent channel selectivity |
at 25KHz
at 12.5KHz |
70dB typ.
65dB typ. | |
| Spurious response rejection |
70 dB (typ.) |
| Audio output power |
500 mW (type.) at 5% distortion an 8 ohm |
| Current drain |
Receive
Transmit |
70 mA (standby)
250 mA (rated audio)
1.6 A (high) | |
| Dimensions (proj. not included) |
54(W) × 128(H) × 37(D) mm |
| Weight |
310 g (with BP-209) |
Measurements made in accordance with EAIA-152-C/204D or TIA-603.
Applicable U.S. Military Specifications
Icom makes rugged products that meet MIL-STD requirements and strict environmental standards as follows.
| Standard |
MIL 810 C |
MIL 810 D |
MIL 810 E |
MIL 810 F |
| Method |
Proc |
Method |
Proc |
Method |
Proc |
Method |
Proc |
| Low Pressure |
500.1 |
I |
500.2 |
I, II |
500.3 |
I, II |
500.4 |
I, II |
| High Temp. |
501.1 |
I |
501.2 |
I, II |
501.3 |
I, II |
501.4 |
I, II |
| Low Temp. |
502.1 |
I |
502.2 |
I, II |
502.3 |
I, II |
502.4-3 |
I, II |
| Temp. Shock |
503.1 |
I |
503.2 |
I |
503.3 |
I |
503.4 |
I |
| Solar Radiation |
505.1 |
I |
505.2 |
I |
505.3 |
I |
505.4 |
I |
| Rain |
506.1 |
I, II |
506.2 |
I, II |
506.3 |
I, II |
506.4 |
I, II |
| Humidity |
507.1 |
I, II |
507.2 |
II, III |
507.3 |
III |
507.4 |
– |
| Salt Fog |
509.1 |
I |
509.2 |
I |
509.3 |
I |
509.4 |
– |
| Dust Blowing |
510.1 |
I |
510.2 |
I |
510.3 |
I |
510.4 |
I |
| Vibration |
514.2 |
VIII, X |
514.3 |
I |
514.4 |
I |
514.5 |
I |
| Shock |
516.2 |
I, II, V |
516.3 |
I, IV |
516.4 |
I, V |
516.5 |
I, V |
All stated specifications are subject to change without notice or obligation.
Supplied Accessories
- Battery pack:BP-209
- Antenna
- Belt clip: MB-68
- Battery charger*, AC adapter*
* Depending on version
|
| |
Simple operation for instant communication
The IC-F3001 series is so easy to use there's no special training required. The few knobs and buttons are generously sized for easy operation and are designed to provide non-slip, positive action — even while wearing gloves.
Easy to hear in noisy areas
The built-in bridge-tied load (BTL) amplifier offers powerful 800mW* audio output from the large 45mm speaker. The radio delivers loud and intelligible audio even in noisy environments.
Typical with internal speaker
Longer operating time
A new, high-efficiency FET reduces current consumption and provides 14 hours* of operating time with the included BP-264 Ni-MH battery. Compact, rugged and long-lasting.
* Power save function ON with 5% TX, 5% RX, and 90% standby.
Weather resistant, dust protection, military rugged
While the radio is a compact unit with a height of only 111mm (43⁄8 inch), the radio is tested to dust protection and water resistant equivalent to IP54 and 11 categories of MIL-STD-810 environmental test. In short, the IC-F3001 series is built rugged!
Internal VOX capability for hands-free operation
The radio has the internal VOX capability for hands-free operation. Optional compatible headset with plug adapter cable OPC-2004 can be used with the radio. Also, the VOX gain and VOX delay time are adjustable.
Selective calling, quiet stand-by and more
2-Tone and 5-Tone signalings give you selective calling, quiet stand-by and other convenient functions with programming. The radio "stun" function disables a radio over the air and the "revive" function restores the stunned radio.
Scan features
The priority scan allows you to monitor one or two priority channels while scanning other non-priority channels. The Tx channel and talk back functions allow you to make a quick response while scanning.
Other features
- DTMF autodial
- Low battery alert
- PC programmable
- Talk around function
- Enhanced emergency
- Surveillance function
- CTCSS/DTCS encoder/decoder
- MDC PTT ID and emergency
- 2-step power save
- Time out timer
- Lone worker function
- 3-color LED
| |
|
|