IcomUSA

The only thing better than our prices is our service
Home      FR3000 Series

Call for systems pricing and configuration. 541-621-4588

Icom FR3000 Series

Frequency coverage (MHz)

IC-FR3000

IC-FR4000

148-172MHz, 150-174MHz

400-430MHz, 430-450MHz, 450-480MHz

No. of channels 32 channels
Channel spacing 12.5/25KHz
PLL channel step 5, 6. 25KHz (2.5kHz, VHF repeater operation only)

Frequency stability

VHF

UHF (U.S.A. version)
UHF (Other versions)

  

±2.5ppm

±1.5ppm < /br> ±2.5ppm

Operating temperature range

-30°C to +60°C

-22°F to +140°F

Power supply voltage

13.6V DC
100-120V AC (50/60Hz)*,

220-240V AC (50/60Hz)*
*Depending on version

Current drain (at 13.6 V DC)
Tx
 
Rx
 
VHF (at 50W)
UHF (at 50W)
Max. audio
Stand-by


15A
20A
2A typ.
1A typ.

Antenna impedance 50Ω (Type-N × 2)
Dimensions (proj. not incl.)

410(W) × 110(H) × 360(D) mm

16 5⁄32 × 4 11⁄32 × 14 3⁄16 in

Weight 12 kg; 26.4lb (approx.)
Transmitter
Output power 50W (high), 10W (low) selectable (at 13.6V DC)
Max. frequency deviation ±5.0kHz/±2.5kHz (wide/narrow)
Spurious emissions 70dB
Adjacent channel power 70/60dB (wide/narrow)
Hum and noise 40/34dB (wide/narrow)
Microphone impedance  600 ohm (8-pin modular)
Receiver
Sensitivity 0.25µV typ. (at 12dB SINAD)
Adjacent channel selectivity 70/60dB (wide/narrow)
Spurious response 70dB
Intermodulation rejection ratio 70dB
Hum and noise ratio 40/34dB (wide/narrow)
Audio output power 2.5 W typ. at 10% distortion with a 4 ohm load
External speaker connector  2-conductor 3.5 (d) mm (1⁄8″)/4Ω

Applicable U.S. Military Specifications

Icom makes rugged products that have been tested to and pased the following MIL-STD requirements and strict environmental standards.

Standard

 MIL 810C MIL 810D MIL 810E MIL 810F
Method Proc. Method Proc. Method Proc. Method Proc.
High Temp. 501.1 I 501.2 I, II 501.3 I ,II 501.4 I, II
Low Temp. 502.1 I 502.2 I, II 502.3 I, II 502.4-3 I, II
Vibration 514.2 VII, X 514.3 I 514.4 I 514.4 I
Shock 516.2 I, II, IV 516.3 I, IV 516.4 I, IV 516.5 I, IV

Measurements made in accordance with EIA/TIA-603-A. Compatibility of functions for use with a telephone line may not work in some countries. All stated specifications are subject to change without notice or obligation.

Rear View



 

50 Watt continuous full duty cycle operation

This repeater looks as good as it performs. A rugged heatsink, large cooling fans and a high performance power module provide the repeater with a stable 50W at full duty cycle operation.

Automatic battery backup system

A built-in backup system supports automatic switching to an external power supply (13.6V DC) if the AC power supply fails.

Multiple CTCSS & DTCS tone memories with multiple memory channels

Up to 16 CTCSS/DTCS tones (TX/RX tones respectively) can be programmed in a channel. This feature allows you to share a channel with multiple user groups. You can also give priority/exclusive use to a specified group simply by programming different tones to another memory channel. Ideal for many different applications.

Built-in 2-Tone, 5-Tone, DTMF encoder & decoder

Multiple signaling systems are equipped as standard. These systems are fully compatible with Icom F-series radios.

Internal space for duplexer and isolator

The repeater has an internal space to install a duplexer and isolator*. The controls of the duplexer are accessible from the front of the repeater without disassembly. Faster and easier maintenance and adjustment is possible.
* Ask your dealer for details about available duplexers and isolators.

Telephone interconnect capability

DTMF remote control capability

You can control the repeater from a remote location over the air or over a phone line with DTMF.

Optional wall mount bracket, MB-77 and 19 inch rack mount bracket, MB-78

IC-FR3000 / IC-FR4000
19-inch rack mount, MB-78		 IC-FR3000 / IC-FR4000
Installation on a wall with the MB-77

Additional Features

  • Master/Slave backup operation by connecting two repeaters
  • Self check function checks for internal errors and alerts with a beep sound or with a phone call
  • Accessory connector (D-sub 25-pin) on the rear panel for trunking controller including LTR, PassPort, SmarTrunkΙΙ and MPT1327
  • Compatible with VEGA tone remote control system
  • 5-Tone relay function
  • Optional Voice Scrambler UT-109 or UT-110
  • CW ID transmitter (DTMF or 5-Tone also selectable)
  • Password and kill/stun function for security
  • 16-digit alphanumeric display convenient for base station operation
  • A programmable button gives access to a customized function

All trademarks are the properties of their respective holders.